
The edge of a cheesecake can look finished while the middle still trembles when you nudge the pan. That little wobble is worth paying attention to here: this peppermint cheesecake bakes gently in a water bath, then rests in the turned-off oven before it gets chilled. The result is a smooth, creamy center with a buttery graham cracker crust and a cool peppermint note that doesn’t drown out the cream cheese.
I keep the peppermint measured rather than pouring by instinct. Peppermint extract is potent, and the crushed candies add another bright, minty hit on top. Room-temperature cream cheese, sour cream, and eggs also make the filling easier to beat smooth, so there’s no need to chase lumps around the bowl. After the long chill, a cloud of whipped cream and the candy crunch make each slice feel finished without making the cheesecake itself too sweet.

Kitchen Note
Let the cream cheese, sour cream, and eggs come to room temperature before mixing. Cold ingredients are harder to blend into a smooth filling, and overbeating later to chase lumps can add too much air.
Save this peppermint cheesecake for its creamy center, graham cracker crust, and crisp candy topping.
Why a Cheesecake Water Bath Is More Than Crack Insurance
A water bath does more than help prevent surface cracks. It surrounds the springform pan with hot water, so the cheesecake heats gently instead of taking the oven’s dry, direct heat all at once. That slower, more even cooking helps the filling set without turning the outer ring rubbery while the center catches up. You’ll still see a slight jiggle in the middle when the cheesecake is ready to leave the oven.
The foil around the pan matters because the water bath should stay outside the cheesecake, not seep through the springform seam and soften the crust. Use two layers of heavy-duty foil and cover the bottom and sides before setting the pan in the roasting pan. Pour the hot water around it only after it’s in place, aiming for water halfway up the sides. This extra setup is worth it for a cheesecake with a tender, even texture from edge to center.
What the Cream Cheese, Sour Cream, and Peppermint Each Bring

- Cream cheese — It gives the filling its structure and rich, tangy body. Use softened cream cheese that blends smooth; a cold, firm block is more likely to leave lumps. I wouldn’t swap in a whipped spread, since its airy texture changes how the filling sets.
- Sour cream — At room temperature, it loosens the dense cream cheese mixture and brings a gentle tang. Its thickness matters here; a thinner dairy product would change the filling’s consistency, so I don’t recommend an untested one-for-one swap.
- Eggs — They help the filling set as it bakes. Room-temperature eggs blend in more evenly, and adding them one at a time keeps you from working extra air into the batter.
- Peppermint extract and vanilla — Peppermint gives the cheesecake its cool character, while vanilla rounds out the dairy and sugar. Extracts vary in strength by brand, so measure carefully rather than adding extra by feel.
- Graham cracker crumbs and melted butter — The crumbs make a crisp, buttery base, and the butter helps them hold together after baking. Evenly moistened crumbs press into a more cohesive crust than dry patches mixed with buttery clumps.
- Heavy whipping cream and peppermint candies — Cold cream whips into a topping that contrasts with the dense filling; powdered sugar sweetens it without adding graininess. Add the crushed candies just before serving so their crunch stays distinct.
Build the Crust and Filling Without Overworking Either
Press and Bake the Graham Cracker Base
Heat the oven to 350°F and grease the bottom and sides of a 9-inch springform pan. Stir the graham cracker crumbs with the granulated sugar, then mix in the melted butter until the crumbs look evenly moistened. Press the mixture firmly across the bottom of the pan, keeping the layer level so it bakes evenly. Bake the crust for 10 minutes, then reduce the oven to 325°F for the cheesecake.
Mix a Smooth, Gently Aerated Filling
Beat the softened cream cheese and sugar on medium speed until smooth, scraping down the bowl as needed so no thick patches remain along the sides. Mix in the sour cream, vanilla, peppermint extract, and salt. Add the eggs one at a time on low speed, stopping as soon as each is incorporated; beating longer can add extra air that expands in the oven and then falls. Pour the finished filling over the baked crust.
Set Up the Pan for Its Water Bath
Wrap the outside of the springform pan with two layers of heavy-duty foil, covering the bottom and sides. Set it inside a large roasting pan before adding hot water, which is easier than carrying a filled roasting pan across the kitchen. Pour in enough hot water to reach halfway up the sides of the springform pan. Keep the water below the top edge of the foil so it stays outside the cheesecake.
Bake Until the Center Reaches 160°F
Bake at 325°F for 75 to 95 minutes. The edges should look set, and the center should still move with a gentle jiggle; check that the center reaches 160°F. The wide time range reflects how ovens and pans can vary, so use the center temperature and visual cues together rather than pulling it at the first sign of a set edge. Turn off the oven, crack the door, and let the cheesecake cool inside for 1 hour.
Cool, Chill, and Finish Just Before Serving
Lift the springform pan out of the water bath, remove the foil, and cool the cheesecake to room temperature. Cover it and refrigerate for at least 6 hours, until thoroughly chilled. Beat the cold heavy cream with the powdered sugar in a chilled bowl until medium peaks form, then spread or pipe it over the cheesecake. Sprinkle the crushed peppermint candies over the top just before serving.
Three Ways to Adjust the Peppermint Cheesecake Finish
Keep the Top Candy-Free
Leave off the crushed peppermint candies and finish with the whipped cream alone. The cheesecake still has peppermint extract in the filling, while the top stays smooth and soft instead of adding a crunchy, extra-sweet bite.
Make It a Bare Peppermint Cheesecake
Skip the whipped cream, powdered sugar, and crushed candy topping for a clean, unadorned finish. The slice will taste richer and less sweet on top, and you won’t have to whip anything at serving time.
Choose a Softer Peppermint Note
Leave the peppermint extract out of the filling and keep the crushed candies on top. You’ll get a milder mint impression, with most of the peppermint coming from the finishing layer rather than running through every bite.
Storage and Reheating
- Refrigerator: Cover and refrigerate leftovers for up to 4 days. The crust softens gradually as it sits, but the filling stays creamy.
- Freezer: Freeze the chilled cheesecake before adding whipped cream or candies. Wrap portions tightly and freeze for up to 1 month; thaw overnight in the refrigerator, then add the topping.
- Reheating: Serve it cold; cheesecake doesn’t need reheating. Don’t warm it to soften a firm slice, because the filling can lose its clean, set texture.
Questions That Come Up While Making Peppermint Cheesecake

Peppermint Cheesecake
Ingredients
Equipment
Method
- Heat the oven to 350°F.
- Grease the bottom and sides of a 9-inch springform pan.
- Stir the graham cracker crumbs and sugar together.
- Mix in the melted butter until evenly moistened.
- Press the crust firmly over the bottom of the pan.
- Bake for 10 minutes.
- Reduce the oven temperature to 325°F.
- Wrap the outside of the springform pan with two layers of heavy-duty foil, covering the bottom and sides.
- Beat the cream cheese and sugar in a large bowl on medium speed until smooth, scraping down the bowl as needed.
- Mix in the sour cream, vanilla, peppermint extract, and salt.
- Add the eggs one at a time, mixing on low just until each is incorporated.
- Pour the filling over the crust.
- Set the foil-wrapped pan in a large roasting pan.
- Pour in enough hot water to come halfway up the springform pan's sides.
- Bake at 325°F for 75 to 95 minutes, until the edges are set and the center reaches 160°F.
- Turn off the oven, crack the door, and let the cheesecake cool in the oven for 1 hour.
- Lift the springform pan out of the water bath and remove the foil.
- Cool to room temperature.
- Cover and refrigerate for at least 6 hours, until thoroughly chilled.
- Beat the cold heavy cream and powdered sugar in a chilled bowl until medium peaks form.
- Spread or pipe the topping over the chilled cheesecake.
- Sprinkle with the crushed peppermint candies just before serving.